Paper and binding
Does changing the paper change my spine width?
It can. Spine width depends on the thickness of the leaves, the page count and the binding. Two stocks with the same GSM can give the same book different spine widths.
Count leaves once
A 160-page double-sided interior has 80 leaves. If a calculator asks for pages, enter 160. If you estimate from the thickness of a single leaf, multiply that thickness by 80. Include intentional blanks and front matter in the PDF count.
Page labels printed in the book can be misleading. A novel might have eight pages of preliminaries followed by a story numbered 1 to 152. That is a 160-page interior if there are no other pages. Check the total page count in the exact PDF being sent to production and keep the cover file separate. Recount after adding an acknowledgements page or an intentional blank.
See the size of the difference
At an illustrative 0.10 mm per leaf, 80 leaves form an 8 mm stack. At 0.12 mm, they form a 9.6 mm stack. That 1.6 mm difference can shift spine lettering or carry a patch of colour onto the front. These figures illustrate the arithmetic for an unbound stack.
Caliper is thickness, often stated in microns or millimetres per sheet. One thousand microns make one millimetre. If the supplier quotes 105 microns per sheet, use 0.105 mm per leaf in this rough calculation. If they quote the thickness of a whole stack, first divide by the number of leaves in that stack. Write the unit next to the number to avoid a thousandfold error.
Regenerate the cover
Ask for the caliper or a measured dummy of the chosen stock and the printer’s final binding template. Update the back, spine and front together. Inspect narrow lettering and colour transitions on a folded proof. A hardcover needs a case template with its own hinge and wrap allowances.
Before changing the design, save the approved previous cover alongside its matching interior. Open the new template at actual size and compare the back panel, each spine fold and the front panel. A centred title may need a new position, while a photograph spanning both panels may need a different crop. Stretching all artwork to fit the new overall width also distorts the lettering.
Calculate what changes across a flat cover
Take an A5 paperback with a 148 mm front panel and a 148 mm back panel. With an illustrative 8 mm spine, the trimmed flat cover is 304 mm wide. A 9.6 mm spine makes the trimmed width 305.6 mm. For this example only, assume the printer asks for 3 mm bleed at each outer edge. The respective file widths become 310 mm and 311.6 mm. The height stays the same because the trim height and the top and bottom bleed have stayed the same.
That extra width belongs between the cover panels. If the back stays anchored, the front moves by 1.6 mm and the centre of the spine moves by 0.8 mm. Put guides at the two spine edges and check the distance from each edge to the lettering. A narrow stripe that was centred on the old spine makes a good visual test.
Record what is still an estimate
Ask the printer which stock, final page count and binding their supplied template assumes. Note the date and save it with the print files. Check one bound proof, first from the front and then with the spine facing you. If the fold lands across the title, photograph the closed proof and mark which direction the artwork needs to move. Use the printer’s confirmed measurement for approval.